USG40 problem VPN SecuExtender Tap-Windows Adapter V9
Options
Freshman MemberGood morning,
after the last firmware update to version 4.32 (AALA.0) C0 with SecuExtender client version 4.0.3.0 installed on windows 10, I encounter a client-side problem on the release of the IP to the Tap-Windows Adapter V9 adapter, as if a incorrect ip address. This causes the inability to enter the corporate network.
The only way is to manually configure the IPv4 in Tap-Windows Adapter V9
thank you
0
All Replies
-
You have the same symptom as that in the following discussion.Workaround- Set subnet in "Assign IP Pool" and the issue is resolved.Solution- Wait for firmware 4.33.0
-
thank you, I will try immediately
0
Master MemberCategories
- All Categories
- 442 Beta Program
- 3.1K Nebula
- 243 Nebula Ideas
- 6.8K Security
- 781 USG FLEX H Series
- 387 Security Ideas
- 1.8K Switch
- 87 Switch Ideas
- 1.5K Wireless
- 58 Wireless Ideas
- 7.2K Consumer Product
- 324 Service & License
- 527 News and Release
- 101 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 5.3K FAQ
- 34 Documents
- 91 About Community
- 121 Security Highlight
