USG40 problem VPN SecuExtender Tap-Windows Adapter V9
Options
Freshman Member
Good morning,
after the last firmware update to version 4.32 (AALA.0) C0 with SecuExtender client version 4.0.3.0 installed on windows 10, I encounter a client-side problem on the release of the IP to the Tap-Windows Adapter V9 adapter, as if a incorrect ip address. This causes the inability to enter the corporate network.
The only way is to manually configure the IPv4 in Tap-Windows Adapter V9
thank you
0
All Replies
-
You have the same symptom as that in the following discussion.Workaround- Set subnet in "Assign IP Pool" and the issue is resolved.Solution- Wait for firmware 4.33.0
-
thank you, I will try immediately
0
Master Member
Categories
- All Categories
- 442 Beta Program
- 3K Nebula
- 223 Nebula Ideas
- 129 Nebula Status and Incidents
- 6.6K Security
- 635 USG FLEX H Series
- 356 Security Ideas
- 1.8K Switch
- 85 Switch Ideas
- 1.4K Wireless
- 54 Wireless Ideas
- 7K Consumer Product
- 301 Service & License
- 494 News and Release
- 92 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.8K FAQ
- 34 Documents
- 88 About Community
- 109 Security Highlight
