usgflex nebula registration

MassimoRiva

hi I would like to know if I have a usgflex in production and I decide to register it on NCC the device must resetted to factory default configuration? or it is possible to register it with the production configuration?

thank you.

Xydocq

Registering a USG Flex with nebula will erase all on-premise settings.

I know that you can pre-configure the USG Flex on Nebula before installing. I don't know if it will work with an USG Flex that is already in use.

Zyxel_Judy

Hi @MassimoRiva ,

In addition to @Xydocq suggestion, you also can use Nebula Cloud Monitor mode to monitor your USG FLEX remotely on cloud while still configuring it through the on-premises interface.

https://community.zyxel.com/en/discussion/18540/atp-flex-how-to-set-up-nebula-monitor-mode

Xydocq

Registering a USG Flex with nebula will erase all on-premise settings.

I know that you can pre-configure the USG Flex on Nebula before installing. I don't know if it will work with an USG Flex that is already in use.

Zyxel_Judy

Hi @MassimoRiva ,

In addition to @Xydocq suggestion, you also can use Nebula Cloud Monitor mode to monitor your USG FLEX remotely on cloud while still configuring it through the on-premises interface.

https://community.zyxel.com/en/discussion/18540/atp-flex-how-to-set-up-nebula-monitor-mode

MassimoRiva

hi Judy thank you. I'm looking for an alternative of CNC (end of life) portal to remote manage/send alert/firmware management of remote firewall. you answered to my reserch. till now I used nebula portal only with a base subscription to manage the AP. I think that nebula don't have all control of the security gateway (same as on-prem management). Regards.