How do I check which port number the Ethernet interface belongs to on the USG Flex H using the CLI?

Zyxel_Jeff

Question :

How do I check which port number the Ethernet interface belongs to on the USG Flex H using the CLI?

Answer :

For example, the USG Flex 200HP has ports ge1 to ge4, which are mapped to P1 to P8 by default.

The user can use the CLI command "show state vrf main interface ethernet geX ports" to check which corresponding port number it is mapped to. As shown in the example below:

usgflex200hp> show state vrf main interface ethernet ge1 ports
ports p1
usgflex200hp> show state vrf main interface ethernet ge2 ports
ports p2
usgflex200hp> show state vrf main interface ethernet ge3 ports
ports p3
ports p4
ports p5
ports p6
usgflex200hp> show state vrf main interface ethernet ge4 ports
ports p7
ports p8