[NEBULA] How to configure PPPoE or static IP address for WAN interface of NSG?

Zyxel_CSO
Posts: 338
Zyxel Employee





NSG's WAN interface is configured as DHCP by default.
If you want to configure PPPoE or static IP address, you may access the WebGUI of NSG and go to Configuration > Interface to edit the WAN interface.
PPPoE:

Static IP:

Remember to fill the required information and click OK.
P.S.
1. If your NSG has never been online on NCC yet, the default username/password of WebGUI is admin/1234.
2. If your NSG is already online on NCC, you may find the username/password at Configure > Site settings > Device configuration > Local credentials.
If you want to configure PPPoE or static IP address, you may access the WebGUI of NSG and go to Configuration > Interface to edit the WAN interface.
PPPoE:

Static IP:

Remember to fill the required information and click OK.
P.S.
1. If your NSG has never been online on NCC yet, the default username/password of WebGUI is admin/1234.
2. If your NSG is already online on NCC, you may find the username/password at Configure > Site settings > Device configuration > Local credentials.
Tagged:
0
Categories
- All Categories
- 192 Beta Program
- 1.7K Nebula
- 93 Nebula Ideas
- 63 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 51 Switch Ideas
- 920 WirelessLAN
- 28 WLAN Ideas
- 5.4K Consumer Product
- 174 Service & License
- 296 News and Release
- 65 Security Advisories
- 14 Education Center
- 1K FAQ
- 453 Nebula FAQ
- 258 Security FAQ
- 100 Switch FAQ
- 115 WirelessLAN FAQ
- 22 Consumer Product FAQ
- 67 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 52 Security Highlight