[NEBULA] What is SNMP feature on Nebula Control Center ?
Options
Zyxel_CSO
Posts: 385 Zyxel Employee
Enable SNMP V1/V2c on NCC allows third party to monitor and configure Nebula devices according to specifying the community string. This SNMP Community string with GET and SET behaviors will apply to all the Nebula devices that are registered in the site.
The setting steps are as following:
Please submit a request ticket If you would like to use MIB files for the purpose of surveillance and configuration on third party devices.
Go to Help > Support Request > Open > New Case on NCC, then we will proceed to provide these MIB files for you.
P.S. It is highly recommended that using MIB files for monitoring only, otherwise any configure change could clash with NCC settings.
The setting steps are as following:
- Configure > Site setting > SNMP > SNMP access > enable V1/V2c
- Specify the SNMP Community string
- Click Save button
Please submit a request ticket If you would like to use MIB files for the purpose of surveillance and configuration on third party devices.
Go to Help > Support Request > Open > New Case on NCC, then we will proceed to provide these MIB files for you.
P.S. It is highly recommended that using MIB files for monitoring only, otherwise any configure change could clash with NCC settings.
0
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 415 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight