No possibility to configure NAS

Christophoro

Hello,

I'm trying to configure my NAS326. I have to harddisks connected as RAID1 disk.

When I'm logging in using browser (any browser, few computers) - I can see no icons to set anything.

I can see them - when I pull disks out I've upgraded firmware to newest version, but it didn't help.

But I can see and connect network folders... I have no idea what shoud I do. Did anyone faced the problem as well?

#NAS_June_2020

Sakura_T

When I'm logging in using browser (any browser, few computers) - I can see no icons to set anything.

No icons on the page? have you tried clean browser cache? or using incognito mode?

I can see them - when I pull disks out  I've upgraded firmware to newest version, but it didn't help.

How about put in another new disk? maybe something wrong on the old ones.

Christophoro

Hi,

I've tryied on new installed browser as well - Explorer, Chrome, Firefox.

I can see icons when I take disks out... It's quite hard to find two 2TB disks and replace them... there is a lot of data... But raid and disks are healthy - this is information from NAS... (I can put icon on the bottom line of panel). Icons on the top  in header - doesn't work as well

Mijzelf

If it does work when the disks are out, then you might have a misbehaving package. In that case a factory reset might do the trick.