No possibility to configure NAS
Options
Christophoro
Posts: 2 Freshman Member
Hello,
I'm trying to configure my NAS326. I have to harddisks connected as RAID1 disk.
When I'm logging in using browser (any browser, few computers) - I can see no icons to set anything.
I can see them - when I pull disks out I've upgraded firmware to newest version, but it didn't help.
But I can see and connect network folders... I have no idea what shoud I do. Did anyone faced the problem as well?
#NAS_June_2020
0
Comments
-
When I'm logging in using browser (any browser, few computers) - I can see no icons to set anything.No icons on the page? have you tried clean browser cache? or using incognito mode?I can see them - when I pull disks out I've upgraded firmware to newest version, but it didn't help.How about put in another new disk? maybe something wrong on the old ones.0
-
Hi,I've tryied on new installed browser as well - Explorer, Chrome, Firefox.I can see icons when I take disks out... It's quite hard to find two 2TB disks and replace them... there is a lot of data... But raid and disks are healthy - this is information from NAS... (I can put icon on the bottom line of panel). Icons on the top in header - doesn't work as well0
-
If it does work when the disks are out, then you might have a misbehaving package. In that case a factory reset might do the trick.
0
Categories
- All Categories
- 393 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 906 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 221 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight