[NEBULA] VPN Alerts but tunnel is up and active
Freshman Member
When we activate the VPN alerts we receive an alert about every 15 minutes. However, the tunnel is up as we have been running a ping monitor to test traffic. This is only happening at one site. Others are working and alerting like normal,
How does the alert test tunnels? I did see the post about subnets and making sure the remote gateway called in the addressing/setup. Support has been of no help.
How does the alert test tunnels? I did see the post about subnets and making sure the remote gateway called in the addressing/setup. Support has been of no help.
0
All Replies
-
Hello @MarkSL
May I know if the corresponding site has also receive the alert mail?
I will PM you of the further needed information, please check your inbox message.
/ChrisChris
0 -
PM sent0
-
Hello Community,
Update this case, the issue occurred because of the mis-configuration on NAT traversal and conflict LAN subnet the symptom resolved after the correction.
/ChrisChris
0
Zyxel Employee
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
