Block client
Freshman Member
How do I from the Nebula Control Center permanently block a client from using the network (both for wired and wireless devices)?
Best Answers
-
Hello @HummervikenITAB
For wireless user you can block it in Access point>Monitor>Clients, select the client in policy then block. You can also select "Normal" to unlock.
For the wired user you can use ACL in Switch>Configure>ACL (type target MAC address in source MAC address), please be aware that it is the site-wide setting if you have 3 switch in this site then the ACL configuration will apply on all the switch.
5 -
Sorry, but in current stage we do not support it in schedule, but I can put this input to the idea section and anyone who like this idea can press like button or leave the comment below.?
5
Zyxel Employee
All Replies
-
Hello @HummervikenITAB
For wireless user you can block it in Access point>Monitor>Clients, select the client in policy then block. You can also select "Normal" to unlock.
For the wired user you can use ACL in Switch>Configure>ACL (type target MAC address in source MAC address), please be aware that it is the site-wide setting if you have 3 switch in this site then the ACL configuration will apply on all the switch.
5 -
Thank you Chris,
This was exactly what I was looking for.
Is there any way to schedule rules for these settings?
0 -
Sorry, but in current stage we do not support it in schedule, but I can put this input to the idea section and anyone who like this idea can press like button or leave the comment below.?
5
Categories
- All Categories
- 429 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 350 USG FLEX H Series
- 291 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 406 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight
