Block client
How do I from the Nebula Control Center permanently block a client from using the network (both for wired and wireless devices)?
Best Answers
-
Hello @HummervikenITAB
For wireless user you can block it in Access point>Monitor>Clients, select the client in policy then block. You can also select "Normal" to unlock.
For the wired user you can use ACL in Switch>Configure>ACL (type target MAC address in source MAC address), please be aware that it is the site-wide setting if you have 3 switch in this site then the ACL configuration will apply on all the switch.
Chris
5 -
Sorry, but in current stage we do not support it in schedule, but I can put this input to the idea section and anyone who like this idea can press like button or leave the comment below.?
Chris
5
Zyxel EmployeeAll Replies
-
Thank you Chris,
This was exactly what I was looking for.
Is there any way to schedule rules for these settings?
0
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
