Block client

HummervikenITAB · February 2020

How do I from the Nebula Control Center permanently block a client from using the network (both for wired and wireless devices)?

[Deleted User] · February 2020

Hello @HummervikenITAB

For wireless user you can block it in Access point>Monitor>Clients, select the client in policy then block. You can also select "Normal" to unlock.

For the wired user you can use ACL in Switch>Configure>ACL (type target MAC address in source MAC address), please be aware that it is the site-wide setting if you have 3 switch in this site then the ACL configuration will apply on all the switch.

[Deleted User] · February 2020

@HummervikenITAB

Sorry, but in current stage we do not support it in schedule, but I can put this input to the idea section and anyone who like this idea can press like button or leave the comment below.?

[Deleted User] · February 2020

Hello @HummervikenITAB

For wireless user you can block it in Access point>Monitor>Clients, select the client in policy then block. You can also select "Normal" to unlock.

For the wired user you can use ACL in Switch>Configure>ACL (type target MAC address in source MAC address), please be aware that it is the site-wide setting if you have 3 switch in this site then the ACL configuration will apply on all the switch.

HummervikenITAB · February 2020

Thank you Chris,

This was exactly what I was looking for.

Is there any way to schedule rules for these settings?

[Deleted User] · February 2020

@HummervikenITAB

Sorry, but in current stage we do not support it in schedule, but I can put this input to the idea section and anyone who like this idea can press like button or leave the comment below.?

Block client

Best Answers

All Replies

Categories

Nebula Tips & Tricks

Nebula Help Center