[NEBULA] NSG 50 Bridged mode
Options
Paolino1200
Posts: 2
Hello,
is it possible to configure a NSG 50 in bridged mode? I need to install a firewall in a network without changing internal ip addresses...
thanks.
is it possible to configure a NSG 50 in bridged mode? I need to install a firewall in a network without changing internal ip addresses...
thanks.
0
All Replies
-
Hi @Paolino1200
Welcome to the forum.
I am not expert but i do not think NSG50 could be configured in bridged mode.
If you show us your environment, perhaps we could give you another options.
Regards0 -
Thx for your answer Alfonso, my customer has a dvr and another security device behind a fastweb router. this router is configured with port forwarding and Nat towards that internal devices. To improve security we need to install a firewall without changing router configuration and ip address of internal devices.0
-
@Paolino1200
How about configuring router mode for NSG?
In my understanding, router mode will not change the source IP to NSG's WAN IP when LAN client's traffic goes through WAN interface.
But, you might need to configure routing policy on other devices to let them know the client is behind NSG.
Maybe you may share your topology and what you expect.0
Categories
- All Categories
- 392 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 220 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight