New NAS and findme does not work
Options
Flatinz
Posts: 1 Freshman Member
Just connected a new NAS540 with two WD Reds 4TB each in slots 1 and 2. Problems is the https://findme.zyxel.com/nas is not finding my NAS. I start the search then press the copy button and nothing is found. Everything seem to be working, powered on, connected to a router with flashing lights, lights are on showing the two drives along with the connected symbol. Installed the ZyXel tool and it seems I can configure but that is it. The option to run the initialization wizard brings up a browser and then fails. Anyone run into this problem?
#NAS_March
#NAS_March
0
All Replies
-
Seems, that your Nas did not get IP Address from your Router. Maybe you powered on, before that. So the Nas gives itself an IP by own.
So first check in your Router menue, if there is your Nas present and if there is DHCP-Server enabled. If not, pls. enable.
Then check on the back of your Nas. There should be a small hole for reset.
Use a paper clamb for it: while pressing, you will hear a beep. Continue. 2 beeps. Continue 5 more seconds. All settings ( e.g. wrong IP) will be erased. Use again Nas-seeker.
1
Categories
- All Categories
- 396 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 86 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 916 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight