Static IP for Multy Plus in Bridge Mode?

Options
Skoobaskunk
Skoobaskunk Posts: 3 image  Freshman Member
edited May 2019 in Multy WiFi System
Is it possible to assign a static IP address to the Multy Plus (WSQ60) whilst the device is in Bridge/AP mode?

I managed to achieve this during the inital set-up of the primary device (I have 3 WSQ60's in my current configurartion) in router mode, which then carried over when the mode was chnaged to Bridge mode.  However, I then needed to change the static IP to another address and I now just get presented with a 10.0.0.1 range and my IP changes aren't saved, despite the device telling me that my changes have been saved.

My Billion 7800DX handles all DHCP allocation and I have a reserved range from 192.168.1.4 - 35 and ideally wanted to assign each Multy a static address from the end of this range 33, 34 and 35 respectively.



#MultyPlus_May_2019

Comments

  • Hanamichi
    Hanamichi Posts: 125 image  Ally Member
    edited May 2019
    Options
    Hi Skoobaskunk,

    If your WSQ60 is bridge mode, you should able to assign the specified IP address to it from upper layer router. I checked User Manual of BiPAC 7800DX(L), it has the feature of Static IP.
    https://www.billion.uk.com/user_manual/User_Manual-BiPAC7800DX-7800DXL.pdf


    For my NBG6817 router, it has Static DHCP feature which I can set the specified IP address to the specified device.

  • Skoobaskunk
    Skoobaskunk Posts: 3 image  Freshman Member
    Options
    Thanks for taking the time to provide such a detailed response, but unfortunately this did not work for me.
  • Skoobaskunk
    Skoobaskunk Posts: 3 image  Freshman Member
    Options
    Correction Hanamichi this worked, just took a while to release the DHCP assigned address and replace it withe static IP.  Thank you so much :)

Categories

Consumer Product Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）