How do you wake the external drive (connected via usb)?

2»

Comments

  • Mijzelf
    Mijzelf Posts: 2,790  Guru Member
    250 Answers 2500 Comments Friend Collector Seventh Anniversary
    Having the disks spinning all the time is not bad for your disks. They wear faster by spinning down and up regularly (and the temperature variations caused by that) than by spinning all the time.

    Having said that, I think the problem is in your USB disk controller. It gets a sleep command after some time, fails to handle that properly.

    There is a work around, but it needs some command line work. By deleting the device node of the usb disk the sleep daemon fails to send that command. This way you can exclude specific disks from sleeping.

  • frigider
    frigider Posts: 18  Freshman Member
    Mijzelf well... since it is not bad to have sleep set to never then the USB drive will not fall asleep either, so i can consider that in a strange twist of faith the problem got itself sorted out :)
  • frigider
    frigider Posts: 18  Freshman Member
    @Emerald Dragon
    well, thanks for the input, no matter.
    good luck on your purchases!
  • Emerald Dragon
    Emerald Dragon Posts: 120  Ally Member
    First Comment Fourth Anniversary
    You are welcome. Same to you as well. I might ended up spending $$$ for the hard drives I needed. LOL! I'll hold out until the next pay check thou, if I can. Or at least close to the time I get pay. ;)

Categories

Consumer Product Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）