after firmware update apps not working
Corwin
Posts: 5 
Freshman Member
Freshman Member
Hello
I have a nas540.
After the recommended firmware update to 5.21 and re-installation of transmission i can't get it work again.
I've tried to install tftp and nfs wit the same result:
just a button with launch and no action at all.
Somebody an idea what i'm doing wrong?
Can't find any file/directory for transmission or daemon or json (via winscp)
Also, no contact for automatic check for updating firmware
thx
I have a nas540.
After the recommended firmware update to 5.21 and re-installation of transmission i can't get it work again.
I've tried to install tftp and nfs wit the same result:
just a button with launch and no action at all.
Somebody an idea what i'm doing wrong?
Can't find any file/directory for transmission or daemon or json (via winscp)
Also, no contact for automatic check for updating firmware
thx
0
Comments
-
Can you refresh it in "All Apps"? you should be able to download the list.
If no, check your network setting (gateway, DNS).1 -
What was your previous firmware version? If that was <5.10, I think you have to remove all packages first, and then reinstall.
1 -
It's working now
put dns to automatic and disabled ipv6
and next removed packages
Thx both
0
Ally Member
Guru MemberCategories
- 8.1K All Categories
- 1.6K Nebula
- 59 Nebula Ideas
- 54 Nebula Status and Incidents
- 4.3K Security
- 222 Security Ideas
- 936 Switch
- 42 Switch Ideas
- 818 WirelessLAN
- 19 WLAN Ideas
- 5K Consumer Product
- 136 Service & License
- 266 News and Release
- 52 Security Advisories
- 13 Education Center
- 536 FAQ
- 252 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 66 About Community
- 44 Security Highlight
Consumer Product Help Center
FAQ