problem with AP after 4.60 upgrade

2»

All Replies

  • IT_Field_Support
    IT_Field_Support Posts: 97  Ally Member
    First Comment Friend Collector Fifth Anniversary

    I will get the list of the site where we have bricked AP and will give you remote access shortly.

    Thanks
  • danyedinak
    danyedinak Posts: 51  Ally Member
    First Comment Friend Collector Sixth Anniversary
    IT_Field_Support said:
    Hi,

    We have issue on a USG40w after 4.60 patch1 upgrade. The AP are not connected anymore and we have an error when trying to manage them :
    error message : -87003
    WTP Log Query  : send capwap event fail

    Thanks for your help,

    IT Field
    I've had this problem on three sites so far, including one running V4.62(AALB.0). The fix (at least on 4.62) was to drop into the command line (I use SSH, presumably the web console would work fine, too) and use the following : 
    configure terminal
    no capwap activate
    (wait about 5 minutes)
    capwap activate
    Within 1 minute of the capwap activate command, the AP's became manageable again and I was able to query the log for the ap once again.
  • Zyxel_Freda
    Zyxel_Freda Posts: 397  Zyxel Employee
    25 Answers First Comment Friend Collector Third Anniversary
    Hi @danyedinak, 
    Would you collect the diagnostic on both AP and the USG for us to check detail when the issue is occurring?
    Thanks.

Categories

Security Highlight


Read more

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）