USG 310 hosts real time bandwidth
Options
Accepted Solution
-
Hi @Briz,
It’s not real-time bandwidth usage. It does not support real-time bandwidth usage on specific IP at current design.
In the Traffic statistics and Session monitor are accumulated bandwidth usage. You can get the highest bandwidth usage by clear/flush data to get latest accumulated bandwidth usage.
0
All Replies
-
In traffic statistics and interface lan1 by host IP you can see the amount used for Tx/Rx0
-
Hi @Briz,
It’s not real-time bandwidth usage. It does not support real-time bandwidth usage on specific IP at current design.
In the Traffic statistics and Session monitor are accumulated bandwidth usage. You can get the highest bandwidth usage by clear/flush data to get latest accumulated bandwidth usage.
0 -
ok thanks, do you plan to add this important information in the near future?
0 -
Hi @Briz,
Thanks for valuable suggestion and we will evaluate it in the future if it is beneficial.

This topic has been move to idea section :
https://community.zyxel.com/en/discussion/10636/real-time-bandwidth-usage-base-on-ip-address#latest
0
Categories
- All Categories
- 441 Beta Program
- 2.9K Nebula
- 208 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.4K Security
- 528 USG FLEX H Series
- 331 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.3K Wireless
- 50 Wireless Ideas
- 6.9K Consumer Product
- 293 Service & License
- 461 News and Release
- 90 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.7K FAQ
- 34 Documents
- 86 About Community
- 99 Security Highlight
Freshman Member
Zyxel Employee
Guru Member