Nebula wlan mesh isolation
Hi, I've just testet a setup with a 203 and a 102 ap where I would like to use the 102 as a mesh point. The problem is that when I connect to the mesh I get isolated. If I do a ip scan I can only see myself and the ap. How to fix so I can access all other devices?
0
All Replies
-
Hi @Cham
We’d like to know if you had connected both APs on Ethernet and ensure they show online on Nebula. Then configured smart mesh enable on both APs and wait their status up to date. After above steps done, move the mesh AP from Ethernet and place it to the location you want to deploy.
Here is the article for setup smart mesh: https://community.zyxel.com/en/discussion/10160
Not sure what tool you use to scan, I connect a PC on root AP and use ZON Utility can scan all the nodes includes repeater AP in the list. Then connect my iPhone to repeater AP and use Network Analyzer can also see the root AP. Can you share with us your test condition after smart mesh build up successfully?
Thanks
Regards,
Bella
0
Categories
- 7K All Categories
- 1.4K Nebula
- 29 Nebula Ideas
- 35 Nebula Status and Incidents
- 3.9K Security
- 200 Security Ideas
- 718 Switch
- 29 Switch Ideas
- 596 WirelessLAN
- 8 WLAN Ideas
- 4.5K Consumer Product
- 97 Service & License
- 215 New and Release
- 38 Security Advisories
- 499 FAQ
- 220 Nebula FAQ
- 120 Security FAQ
- 72 Switch FAQ
- 66 WirelessLAN FAQ
- 5 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 43 About Community
- 31 Security Highlight