FLex 100 WAN Setup Issue
Options
Hi All
Having problems adding PPPOE details to WAN1, all I keep getting is this error..
Currently WAN1 has no IP configuration..
Performed a power cycle but no change and issue is still present in another browser on a different machine. This is a really frustrating one as it makes no sense as all I want to do is add a PPPOE login.
0
Best Answers
-
So I had to plug into another DHCP device to WAN1 that was different to the IP scope on WAN2. Then after removing I could add and save PPPOE details.
0 -
Hi @Pook,We are aware of this issue and are working on it now.We will reply you when it is done.For the workaround currently, just like you said, let WAN1 gets a DHCP IP address which will not overlap with WAN2 from local first, and you may configure PPPOE details on NCC.
Zyxel Melen
0
All Replies
-
So I had to plug into another DHCP device to WAN1 that was different to the IP scope on WAN2. Then after removing I could add and save PPPOE details.
0 -
Hi @Pook,We are aware of this issue and are working on it now.We will reply you when it is done.For the workaround currently, just like you said, let WAN1 gets a DHCP IP address which will not overlap with WAN2 from local first, and you may configure PPPOE details on NCC.
Zyxel Melen
0 -
-
Thanks Melen, I have a Flex 100 to set up next week and I will test :-)
0
Categories
- All Categories
- 392 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 220 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight