Zyxel XMG3927-B50A setting LAN interface to bridged mode
Options
linuxuser
Posts: 3
I'm trying to set a couple LAN interfaces to bridged mode, what I need to do? So far, I have created two new WAN interfaces in bridged mode and then I created two interface groups selecting the newly created WAN interfaces as WAN interfaces and selected the LAN interfaces. Then I rebooted the device.
I have VDSL2 connection.
Images to explain what I did.
When I connected to LAN1, I didn't get a connection.
0
All Replies
-
Hi
According to the images, it seems these two bridge WANs have VLAN.
Not sure if your LAN devices could aware VLAN tags or not.
Maybe it is the reason that you can't get the connection.0 -
I can't create a new WAN interface without specifying both the 802.1p and 802.1q. It says the VLAN is repeat if I don't specify them.
0 -
I ended up setting the whole VDSL interface to bridged mode, not just some LAN ports. I had to disable the DHCP server too.
0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 922 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 997 Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 141 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight