Configuring a complete new organization before buying HW

Sébastien
Sébastien Posts: 41  Freshman Member
First Comment Friend Collector Fourth Anniversary
edited October 2021 in Nebula
Hi everyone,

I just wondered if it is possible to configure a complete multi-site new org on Nebula without buying the HW first ?

The HW is on the road and I have time now for configuring the org while delivery is in progress.

In a blank site, I'm invited to add a firewall/gateway by choosing the model but it doesn't appear in the VPN Orchestrator to prepare the future intersites VPN connections.

One other question : how will I be able to add the MAC/SN number to this firewall later when it will be delivered ? 

Thanks,

Sébastien

Accepted Solution

  • Zyxel_Jason
    Zyxel_Jason Posts: 411  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 1 - Switch Zyxel Certified Network Engineer Level 1 - Nebula Zyxel Certified Sales Associate
    Answer ✓
    Hi @Sébastien,

    Nebula CC supports pre-configure for some settings before the device is registered/added to the site.
    However, you mentioned that you would like to configure Site-to-Site VPN related settings.

    To enable Site-to-Site VPN, you will need the USG FLEX added to the site on NCC.
    If you have already had MAC/SN on your hand before receiving the hardware, you may register/add the MAC/SN to the site first, then you may do the pre-configuration for VPN.

    For registration steps, you may refer to this link.

    Hope it helps.
    Jason

    Share your feedback through our survey, make your voice heard, and win a WiFi 7 AP! https://bit.ly/2024_Survey_Community

All Replies

  • Zyxel_Jason
    Zyxel_Jason Posts: 411  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 1 - Switch Zyxel Certified Network Engineer Level 1 - Nebula Zyxel Certified Sales Associate
    Answer ✓
    Hi @Sébastien,

    Nebula CC supports pre-configure for some settings before the device is registered/added to the site.
    However, you mentioned that you would like to configure Site-to-Site VPN related settings.

    To enable Site-to-Site VPN, you will need the USG FLEX added to the site on NCC.
    If you have already had MAC/SN on your hand before receiving the hardware, you may register/add the MAC/SN to the site first, then you may do the pre-configuration for VPN.

    For registration steps, you may refer to this link.

    Hope it helps.
    Jason

    Share your feedback through our survey, make your voice heard, and win a WiFi 7 AP! https://bit.ly/2024_Survey_Community
  • Sébastien
    Sébastien Posts: 41  Freshman Member
    First Comment Friend Collector Fourth Anniversary
    Hi @Zyxel_Jason,

    Ok so for advanced configuration I need to add a "real" device with SN/MAC first.

    Thanks for your reply.

    Sébastien

Categories

Nebula Tips & Tricks


    Read more

    Nebula Help Center

    EnglishTiếng ViệtРусскийไทย中文（台灣）