NSG100 Failover Wan 2 ?
Options
Headmaster
Posts: 8 
Freshman Member
Freshman Member
in Nebula
Is it possible to config the NSG100 internet connection to Failover to another router with adls/fibre by using WAN2 P2 ? Our main connection is on Wan 1 P1. Any advice or docs would be appreciated, thanks.
0
Best Answers
-
Hi @Headmaster,
Yes, you may configure internet connection to Failover by using WAN2 P2.
Please setup your PPPOE/Static IP setting for WAN2 interface on WEB GUI and then go to Nebula menu security gateway > configure > Traffic shaping to set WAN load balancing algorithm to "Failover" and prefer WAN set "WAN1".
Below is the example:
Hope it helps.Zyxel Melen0 -
Thank you Melen!0
Zyxel Employee
All Replies
-
Hi @Headmaster,
Yes, you may configure internet connection to Failover by using WAN2 P2.
Please setup your PPPOE/Static IP setting for WAN2 interface on WEB GUI and then go to Nebula menu security gateway > configure > Traffic shaping to set WAN load balancing algorithm to "Failover" and prefer WAN set "WAN1".
Below is the example:
Hope it helps.Zyxel Melen0 -
Thank you Melen!0
Categories
- All Categories
- 442 Beta Program
- 2.9K Nebula
- 219 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.5K Security
- 602 USG FLEX H Series
- 344 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.4K Wireless
- 52 Wireless Ideas
- 7K Consumer Product
- 298 Service & License
- 480 News and Release
- 92 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.8K FAQ
- 34 Documents
- 87 About Community
- 105 Security Highlight
