Unable to assign content filter/application patrol policy to security policy
Chris123456
Posts: 3
Freshman Member
Freshman Member
I have a USG FLEX 200 Firewall. It updated recently to Firmware V5.20(ABUI.0).
The security service license is active. I manage the device in NCC.
When I add or change a security policy rule, I am not able to add a content filter or application patrol policy. I even removed an existing policy and tried to revert it to the original state. Unfortunately, I was not able to restore the previous rule.
Does anyone see the same behavior?
0
All Replies
-
I have the same issue..
But I found refresh Pages(F5) . It can work again.0 -
WJS said:I have the same issue..
But I found refresh Pages(F5) . It can work again.
This didn't work for me. I tried with Firefox and Edge.
0 -
0
-
Hi @Chris123456,
Please kindly check the issue was resolved.f
Also Please feel free to contact us if the issue persist.
Kevin0
Ally Member
Master Member
Categories
- 8K All Categories
- 1.6K Nebula
- 60 Nebula Ideas
- 54 Nebula Status and Incidents
- 4.4K Security
- 222 Security Ideas
- 963 Switch
- 45 Switch Ideas
- 865 WirelessLAN
- 20 WLAN Ideas
- 5.2K Consumer Product
- 138 Service & License
- 268 News and Release
- 53 Security Advisories
- 12 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 71 About Community
- 44 Security Highlight
