Armor Z2 - can't access router
Options
Drakkarok
Posts: 1
in Home Router
Hello. I would like to say that my modem works fine, but my Z2 is getting me some trouble.
In CMD i saw that i did not have any gateway (simply blank there), couldn't connect to the router (myrouter and any other didn't work), couldn't reset it (?) because i held the reset button for 15 sec and it didn't do nothing (also tried to hold it when off and start it while pressed - no response either).
The only thing that i saw it's doing is that i have two cables in it and both their lightnings (the little green lights) are turning on and off in the same time (like they are synchronized).
I run out of ideas, what do you think?
In CMD i saw that i did not have any gateway (simply blank there), couldn't connect to the router (myrouter and any other didn't work), couldn't reset it (?) because i held the reset button for 15 sec and it didn't do nothing (also tried to hold it when off and start it while pressed - no response either).
The only thing that i saw it's doing is that i have two cables in it and both their lightnings (the little green lights) are turning on and off in the same time (like they are synchronized).
I run out of ideas, what do you think?
0
All Replies
-
I would say if the device is not working fine after do the reset or the reset button is not working.
I'll do the RMA for the device.0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 79 Nebula Status and Incidents
- 5.1K Security
- 70 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 885 Nebula FAQ
- 415 Security FAQ
- 226 Switch FAQ
- 198 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight