AP DHCP NAT mode bandwidth limit?
On a network we've taken over, there is an SSID is set to DHCP NAT mode across a floor with 6 APs.
As it isn't tied to a VLAN where a central Traffic Shaping policy can be applied on the Security Gateway in Nebula, If we apply a Rate Limit on the SSID, e.g. 10Mb, will this be 10Mb across all 6 access points, or 10Mb per access point?
[edit] Additional query: the Rate Limit withi nthe SSID for DHCP NAT mode has a range of 1Mb to 160Mb, is this 160Mb a limitation imposed by hardware? APs in use are NWA1123 AC Pro.
0
All Replies
-
Hi @CTUK
Rate limit settings are based on SSID, so every device connected to the SSID will get the upper limit of the setup value. As your question, for example: if you have ten devices connected to the SSID which setup Rate limit as 10Mbps, it means devices can get the maximum upper 10Mbps access per device.The other question, we do not have hardware limitations of the setting value. Because we consider the maximum overall wireless throughput,Normally we set the feature with multiple client environments, if we set the upper limit more than 160Mbps, it becomes meaningless because hard to reach the upper limit value, it means the result is the same if we set the value to 0Mbps.
Sincerely
Zyxel_Jay0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 829 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight