[NEBULA] NSG VPN support behind NAT?
Freshman Member
Hey,
I have 2 NSG100. 1 site is behind the NAT but I can't build-up the VPN tunnel... Is this scenario supported?
If yes, how to configure that?
Here's my topology:
site1: NSG100 with Public IP <--> Internet <--> Router <--> site 2: NSG100 with Private IP
I have 2 NSG100. 1 site is behind the NAT but I can't build-up the VPN tunnel... Is this scenario supported?
If yes, how to configure that?
Here's my topology:
site1: NSG100 with Public IP <--> Internet <--> Router <--> site 2: NSG100 with Private IP
0
Accepted Solution
-
Hi ChaCha
Yes, it's supported. Following the path Gateway > Configure> Site-to-site VPN you will find the configuration for NAT Trasversal, you need to input the public IP address your Router is using. As well as, you need to be sure that the NSG100 is mapped in your "Router" device.5
Zyxel EmployeeAll Replies
-
But you can't do that, because it is in use by your router. Seems can only be done with a different external ip. Or Native Interface. Or a different cloud router.
0
Categories
- 7.8K All Categories
- 1.6K Nebula
- 55 Nebula Ideas
- 53 Nebula Status and Incidents
- 4.3K Security
- 217 Security Ideas
- 908 Switch
- 40 Switch Ideas
- 807 WirelessLAN
- 16 WLAN Ideas
- 5K Consumer Product
- 131 Service & License
- 260 News and Release
- 49 Security Advisories
- 6 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 67 About Community
- 40 Security Highlight
