ATP200 firmware update impossible
Options
I have an ATP200 with the following fw versions installed in the flash:
Upgrade of any of these banks is impossible since either trying over FTP, or HTTP, after the upload of 532ABFW0C0.bin is finished, the serial console drops a Firmware not compatible! message.
Can you please advise how can I overcome this situation?
Upgrade of any of these banks is impossible since either trying over FTP, or HTTP, after the upload of 532ABFW0C0.bin is finished, the serial console drops a Firmware not compatible! message.
Can you please advise how can I overcome this situation?
0
All Replies
-
I have also tried with 5.30(ABFW.0) version, but the result was the same...0
-
Maybe try run standby firmware then update it?
0 -
Hi @Peppino,Please follow steps below to update firmware.1) Backup partition 2(current running partition) startup configuration file.2) Reboot on partition 1.(Switch running partition from 2 to 1)3) Update V5.32 firmware on partition 1.4) Apply 1) configuration file on partition 1.0
-
Zyxel_Cooldia said:Hi @Peppino,Please follow steps below to update firmware.1) Backup partition 2(current running partition) startup configuration file.2) Reboot on partition 1.(Switch running partition from 2 to 1)3) Update V5.32 firmware on partition 1.4) Apply 1) configuration file on partition 1.0
-
0
Categories
- All Categories
- 385 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 75 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 908 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 886 Nebula FAQ
- 415 Security FAQ
- 228 Switch FAQ
- 200 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight