ATP200 firmware update impossible
I have an ATP200 with the following fw versions installed in the flash:
Upgrade of any of these banks is impossible since either trying over FTP, or HTTP, after the upload of 532ABFW0C0.bin is finished, the serial console drops a Firmware not compatible! message.
Can you please advise how can I overcome this situation?
Upgrade of any of these banks is impossible since either trying over FTP, or HTTP, after the upload of 532ABFW0C0.bin is finished, the serial console drops a Firmware not compatible! message.
Can you please advise how can I overcome this situation?
0
All Replies
-
I have also tried with 5.30(ABFW.0) version, but the result was the same...0
-
Maybe try run standby firmware then update it?
0 -
Hi @Peppino,Please follow steps below to update firmware.1) Backup partition 2(current running partition) startup configuration file.2) Reboot on partition 1.(Switch running partition from 2 to 1)3) Update V5.32 firmware on partition 1.4) Apply 1) configuration file on partition 1.0
-
Zyxel_Cooldia said:Hi @Peppino,Please follow steps below to update firmware.1) Backup partition 2(current running partition) startup configuration file.2) Reboot on partition 1.(Switch running partition from 2 to 1)3) Update V5.32 firmware on partition 1.4) Apply 1) configuration file on partition 1.0
-
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 115 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 900 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 832 Nebula FAQ
- 402 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight