pla6456 ethernet
diplexer
Posts: 1
Why does my pla6456 ethernet show ETHB as 100 and not 1000 even though I'm connected to a gigabit router with a 300Mbps internet connection? Using cat5e cables.
| Ethernet | |||||||
| External Interfaces: | |||||||
| Interface | Speed | Duplex | Interface Type | Mode | Internal PHY | Link | |
|---|---|---|---|---|---|---|---|
| ETHA | 100 | FULL_DUPLEX | RGMII | MAC | NO | NO | |
| ETHB | 100 | FULL_DUPLEX | SGMII | MAC | NO | YES | |
0
All Replies
-
Hi @diplexer
Please check the router above the PLA if the port speed has been limited to 100M by the router.
If is is not able to change the port speed with the router, you can try to switch other ethernet cable and check if the ETHB still show 100 port speed.0
Zyxel Employee
Categories
- All Categories
- 415 Beta Program
- 2.5K Nebula
- 155 Nebula Ideas
- 105 Nebula Status and Incidents
- 5.9K Security
- 319 USG FLEX H Series
- 286 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.1K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 256 Service & License
- 398 News and Release
- 86 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.7K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 87 About Community
- 78 Security Highlight
