I have 2 NWA110AX and I am unable to setup mesh network.
All Replies
-
We suggest following the steps to check in case the smart mesh can’t build up successfully.
1. Check if setup and configurations are correct.
- You can enable smart mesh for all APs in the site at: Access point > Configure > AP & port settings > General setting > Enable Smart mesh.
- Or you can enable smart mesh for per-APs in the site at: Access point > Monitor > Access point > AP information page > Status > Smart mesh > Enabled.
- Make sure APs are provisioned using wired connection and all APs must show configuration status is "Up to date" before deploying repeater AP into its actual position with connecting the adaptor to power on or connected to a PoE switch.
The path: Access point > Monitor > Access points.
2. Fine-tune the deployment of root and repeater location. APs must be deployed in the signal covered area (recommended –70dBm or above) while uplink AP is within line-of-sight of repeater.
For more detail information please refer to:
https://community.zyxel.com/en/discussion/10160
In case the issue still happens, please enable customer’s Zyxel support by going to the left sidebar > Help > Support request > Invite Zyxel support as administrator, save the changes and provide the Org and Site name for us to check.
Thank you.
Be a Community MVP: Win a VIP Deal Dash on Your Next Zyxel Purchase!
0
Categories
- All Categories
- 385 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 75 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 908 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 886 Nebula FAQ
- 415 Security FAQ
- 228 Switch FAQ
- 200 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight