Change configuration
Options
Mark_Sheephouse_37
Posts: 2 
Freshman Member
Freshman Member
in Nebula
Hi,
I have 2 access points and one keeps showing an orange alert. When I click on it and go to Access point/Monitor/Access point under Link: there is the following 'Uplink: 100M/Full'. If I hovver on the Orange warning triangle it says 'Uplink currently operates at a lower speed 100 Mbps'. When I look at the other Access point it is green and says 'Uplink: 1000M/Full'. ie 1000 not 100. I cannot see anywhere where I can change the setting from 100M to 1000M. FYI I have Swish Full Fibre with Download and Upload speeds of 500Mbps. Any help greatly appreciated.
I have 2 access points and one keeps showing an orange alert. When I click on it and go to Access point/Monitor/Access point under Link: there is the following 'Uplink: 100M/Full'. If I hovver on the Orange warning triangle it says 'Uplink currently operates at a lower speed 100 Mbps'. When I look at the other Access point it is green and says 'Uplink: 1000M/Full'. ie 1000 not 100. I cannot see anywhere where I can change the setting from 100M to 1000M. FYI I have Swish Full Fibre with Download and Upload speeds of 500Mbps. Any help greatly appreciated.
0
All Replies
-
Maybe a bad cable?1
-
There is no configuration to change the setting from 100M to 1000M. The uplink alert based on the current uplink status.
Recommend you changing a cable/ the port that problematic AP connected to check whether the issue solved.
Zyxel_Judy
1
Guru Member
Zyxel Employee
Categories
- All Categories
- 442 Beta Program
- 2.9K Nebula
- 216 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.4K Security
- 570 USG FLEX H Series
- 342 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.4K Wireless
- 52 Wireless Ideas
- 6.9K Consumer Product
- 295 Service & License
- 471 News and Release
- 90 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.7K FAQ
- 34 Documents
- 87 About Community
- 102 Security Highlight
