Create Zone UGS20-VPN

baudetd
baudetd Posts: 40  Freshman Member
First Comment First Anniversary
in Security

hello

i want to link an interface to a zone but i cannot create zone ...thanks

image.png
image.png

Accepted Solution

All Replies

  • PeterUK
    PeterUK Posts: 3,391  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    Do you not have a User Configuration place for adding a zone?

  • baudetd
    baudetd Posts: 40  Freshman Member
    First Comment First Anniversary

    where is User Configuration place ?

    I'm in administrator mode

  • PeterUK
    PeterUK Posts: 3,391  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    configuration > object > zone

  • baudetd
    baudetd Posts: 40  Freshman Member
    First Comment First Anniversary

    hello

    I will explain my request,
    I want to create an independent network on port P3.
    I associated my LAN configuration to port 3
    but for the rest, I created a new zone but it does not work...do you have a procedure

  • PeterUK
    PeterUK Posts: 3,391  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    With the new zone set for P3 you then need to add a firewall rule for that from zone to get out your WAN

  • baudetd
    baudetd Posts: 40  Freshman Member
    First Comment First Anniversary
    edited October 2023

    hello

    I can't find the problem

    I already have a LAN2 which works on port 4

    This is how the control policy is configured for the LAN
    image.png
    image.png

    image.png

    the only difference between lan2 and lan 3 is that I don't have the same zone config

    image.png

  • PeterUK
    PeterUK Posts: 3,391  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary
    edited October 2023

    That should work you do have P3 set with zone LAN3?

    Maybe you need a routing rule

    incoming LAN3

    next hop WAN

    also check your port role in interface that the port set for that zone

  • baudetd
    baudetd Posts: 40  Freshman Member
    First Comment First Anniversary


    Good morning

    the problem is with the role

    if I add the lan3 in the lan 2 role

    it works

    configuration User configuration

    image.png

    is different from the Config configuration. system default

    image.png

    why is it not possible to add a role in the default config?

  • Zyxel_Jeff
    Zyxel_Jeff Posts: 1,230  Zyxel Employee
    100 Answers 500 Comments Friend Collector Fourth Anniversary
    Answer ✓

    Hi @baudetd

    Because the USG20-VPN only has lan1 and lan2 two lan zones by default, therefore needs to manually create lan3 zone. Please refer to this FAQ article How to configure LAN3 zone on USG20(W) and USG Flex 50(W) models? Thanks.


    241015_Speak-up,-Win-WiFi-7_Community-CSO-signature_1920x200.jpg

    Share your feedback through our survey, make your voice heard, and win a WiFi 7 AP! https://bit.ly/2024_Survey_Community

Categories

Security Highlight


Read more

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）