Nebula DNS and access Router WAN
Hello,
two questions.
Question one:
i had change the router and work now with nebula. Before nebula i must change the DNS configuration because the connection breaks temporary down.
After that, all devices work fine.
Now i have the same issue. So i think, i must configure this in nebula too.
But i can't save. What am i doing wrong?
Question 2:
On WAN1 is a AVM Fritz!Box. DHCP work. But i can't ping the router ip as well as i can't access the web interface.
I hope you can understand my not very well english.
Best regards
Ray00731
Accepted Solution
-
You can execute the command to solve this problem
Router(config)# ip dns server zone-forwarder insert 1 * user-defined 8.8.8.8 interface auto
Please note that DO NOT enter “write” after executing the command, otherwise, the device will become standalone mode.0
All Replies
-
You can execute the command to solve this problem
Router(config)# ip dns server zone-forwarder insert 1 * user-defined 8.8.8.8 interface auto
Please note that DO NOT enter “write” after executing the command, otherwise, the device will become standalone mode.0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight