Unable to configure VLAN
Freshman Member
Hello,
Intention is to connect two locations using a VLAN that also secures communication within the VLAN. On two switches (GS1910-24, GS1900-24) I try to aggregate two links in order to increase the available bandwidth and next try to establish the VLAN on both switches. Two Synology boxes consume most of the bandwidth synchronizing each other.
On the GS1910-24 I set up the following static aggregation.
The VLAN setup is as follows:
The aggregated links reside on port 11/12, the local Synology connects to port 20.
On the GS1900-24 switch the aggregation is configures as shown below:
The issue is that the call of the Synology Web Interface times out. Currently I'm stuck and look for some "enlightment" pointing me into the right direction. Do you can lend a hand?
Regards
Martin
Accepted Solution
-
Hi @kmcontact
Since you didn't provide the VLAN setting on GS1900, I assume you might not set the VLAN setting on the LAG port group. Please reference this FAQ to set up the VLAN setting first. If the issue still exists, please share the VLAN setting of GS1900. Thanks in advance.
Zyxel Melen0
Zyxel Employee
All Replies
-
Hi @kmcontact
Since you didn't provide the VLAN setting on GS1900, I assume you might not set the VLAN setting on the LAG port group. Please reference this FAQ to set up the VLAN setting first. If the issue still exists, please share the VLAN setting of GS1900. Thanks in advance.
Zyxel Melen0
Categories
- All Categories
- 429 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 350 USG FLEX H Series
- 291 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 406 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight
