NR7101 IP Passthrough issue in 100ABUV8C0




Hello
got NR7101 with V1.00(ABUV.7)C0 and RG502QEAACR13A02M4G_ZYXEL.
I run it with IP Passthrough mode. Had to create manually the Group interface containing Cellular WAN 1 and LAN1 interfaces together. Otherwise, when I push the "IP Passthrough" mode under "APN configuration" it says that i have to make sure that corresponding interface group is created.
So the issue is when I upgrade to 100ABUV8C0, the IP Passthrough mode doesn't work anymore, my second router gets IP from 192.168.2.0/24, my created group interface disappears and there is new CELL type interface with that group interface name created under Network - Broadband menu (right after Cellular WAN 1 and Cellular WAN 2 interfaces).
just upgraded to 8 and made new screens of that interface. And the is no group interface anymore also.
If i reset to factory using 8 version and create the group interface again, IP Passthrough works but only until I restart the router. Then it comes again - no group interface, new CELL interface and no internet connectionю And I am not allowed to save any changes to this new CELL interface. Can't delete it also. Can't break group interface also, as it disappears.
Any thoughts?
Accepted Solution
-
it was ZY config issue. after I requested config from ISP it is ok now
0
All Replies
-
it was ZY config issue. after I requested config from ISP it is ok now
0
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 174 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 418 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 269 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 87 Security Highlight