Settings for 802.1p Priority in Nebula

Niro96 · January 4

Hello,

Is there a way to configure the priority of the GS1920 ports in Nebula?

greeting
Marcus

Zyxel_Melen · January 8

You can assign a specific VLAN for these individual IP addresses and set the quality of service for this VLAN to achieve your purpose. If these individual IP addresses are assigned to the devices with the same OUI, you can use vendor ID based VLAN for this task.

Niro96 · January 9

Ok. Thank you.

greeting Marcus

Zyxel_Melen · January 11

Hi @Niro96,

In addition, when the switch is in cloud mode, you can change the port priority on the local GUI. For specific IP addresses, please reference the above suggestion.

Zyxel_Melen · January 5

Hi @Niro96,

Currently, Nebula does not support 802.1p on the switch port setting page. But you can configure 802.1p on Site-wide > Configure > Switches > Switch settings page.

Please reference the options below:

Quality of service

Voice VLAN
LLDP-MED:

OUI:

Vendor ID based VLAN

Hope it helps.

Niro96 · January 5

Hello,

Thank you for the info. Can I then prioritize individual IP addresses/ports?
With Vendor ID based VLAN?

greeting
Marcus

Zyxel_Melen · January 8

Hi @Niro96,

You can assign a specific VLAN for these individual IP addresses and set the quality of service for this VLAN to achieve your purpose. If these individual IP addresses are assigned to the devices with the same OUI, you can use vendor ID based VLAN for this task.

Niro96 · January 9

Ok. Thank you.

greeting Marcus

Zyxel_Melen · January 11

Hi @Niro96,

In addition, when the switch is in cloud mode, you can change the port priority on the local GUI. For specific IP addresses, please reference the above suggestion.

Settings for 802.1p Priority in Nebula

Best Answers

All Replies

Categories

Nebula Tips & Tricks

Nebula Help Center