Unable to connect USG FLEX 200 to Nebula Control Center

Options
Stephen378Baker
Stephen378Baker Posts: 1
edited March 2024 in Nebula

Hello,

I have a USG FLEX 200 firewall that I want to register on Nebula control center. I followed the instructions on the Zyxel community, but the device is not showing as connected on NCC. The device is connected to the internet and is passing traffic.

I checked the firmware version on the device and it is 5.37 P2 DogLikesBest. I read that ZIP mode is removed from 5.37 P1 and above, so I tried to use the native mode instead. However, I still cannot get the device to connect to NCC.

Can anyone help me with this issue? Is there a way to downgrade the firmware to 5.37 or another solution? Thanks in advance!

Best regards,
Stephen378Baker

All Replies

  • Zyxel_Cooldia
    Zyxel_Cooldia Posts: 1,570 image  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Sales Associate 100 Answers 1000 Comments

    Hi @Stephen378Baker,

    Please try to downgrade the firmware to V5.37.C0, and then run the ZTP again to provision to NCC. The firmware is provided in the PM.

Categories

Nebula Tips & Tricks


    Read more

    Nebula Help Center

    EnglishTiếng ViệtРусскийไทย中文（台灣）