NR7102 – how to access from behind UDM SE?

JohnnyT76 · June 27

hi there,

just deployed a NR7102. I am using it in IPPT mode and it seems to work fine as a second WAN on the UDM SE even though the connection ist not stable despite very good 5G reception. Any ideas on how to fix this? The UDM SE seems to lose the WAN connection every few seconds. No clue as to why this should be the case…

Now I was trying to access the NR7102 interface from behind the UDM SE via the internal network. I tried using this guide: NR7101 / FWA710 - So stellen Sie den Bridge-Modus ein (mobiles IP-Passthrough) but unfortunately failed so far.

I used the following port forwarding rule within the UDM SE with WAN2 being the Zyxel NR7102:

Unfortunately trying to access from internal LAN via http://192.168.2.1:20080 won´t do the trick. Internal IP addresses distributed via DHCP from the UDM SE are from the 192.168.1.1 range…

Where is my error in trying this?

cheers,

JohnnyT76

JohnnyT76 · July 18

No ideas on how to configure the UDM SE and subsequently the NR7102 in order to access the GUI from the internal LAN while running it in bridge mode?

Cheers,

JohnnyT

Internetheavyuser · July 19

If Internal IP addresses distributed via DHCP from the UDM SE are from the 192.168.1.1

Have you tried

http://192.168.1.1:20080

Also please check the MGMT setting for IPPT.

JohnnyT76 · July 19

Hi there,

thanks for coming back to me.

http://192.168.1.1:20080didn't work, which somehow makes sense since 192.168.1.1 is the IP address of the UDM SE. According to the document the Zyxel should be reachable via LAN in bridge mode via 192.168.2.1 which also does not work.

The settings for the bridge are as follows (accessed via wlan):