192.168.1.1 doesn't work, HELP

Hi @Taz2_0

Edited to correct silly grammar errors!

Follow what @tonygibbs16 below suggests as that is good advice.

Firstly, have you read the manuals - read the quick start guide? I did a quick search for your model, registerd with Zyxel and they gave me access to the quides and manual.

On the rear of your unit you should see the log-in details and WiFi log-in credentials.

Secondly, if you have two devices with the same IP address (I expect all or most of Zyxel devices to be configured as 192.168.1.1 by default) then you will likely not be able to connect to any of them on your network - which device should it connect to?

You'll need to connect only one, your router or your AP to the network, log in to its web page and then change it's default IP address to something different to the default. My advise is to keep probably the main internet router's IP address at it's default, and change the others to a known static address outside of the DHCP range. To change the AP's default IP address, you'll need to have only that one device on your network (unplug your internet router during this stage) and maybe connect that directly into your PC's Ethernet port. When doing this last step, make sure your PC's IP address and subnet are in the 192.168.1.x range, otherwise set the PC IP address to a static address, say 192.168.1.5 and then try log into your device's webpage.

After you've setup the new device with a new IP address, remember to set your PCs IP address back to what it was before (most likely will be to obtain IP from DHCP server), plug your internet router back in and the AP into the that and maybe reboot everything just to be sure all devices configure corretly.

You have to read the manuals.

Regards,

Gordon