NWA130BE Lan Port for VLAN 2

Options
George993
George993 Posts: 21 image  Freshman Member
First Comment First Answer Friend Collector Second Anniversary
edited July 2024 in Nebula

How can I change the LAN port of the NWA130BE to flow all traffic through it to VLAN2?

Thanks,

George

Best Answers

  • davidfi01
    davidfi01 Posts: 26 image  Freshman Member
    First Comment First Answer First Anniversary
    Answer ✓
    Options
    image.png

    Change PVID to "2" in your case - that should work.

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,598 image  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    Answer ✓
    Options

    Hi @George993 ,

    If your access point supports a LAN port, it will be listed at the bottom of the page.

    image.png

    To change the LAN port settings of a specific AP, click on that AP and configure the settings.

    image.png

    Zyxel_Judy

All Replies

  • davidfi01
    davidfi01 Posts: 26 image  Freshman Member
    First Comment First Answer First Anniversary
    Answer ✓
    Options
    image.png

    Change PVID to "2" in your case - that should work.

  • George993
    George993 Posts: 21 image  Freshman Member
    First Comment First Answer Friend Collector Second Anniversary
    Options

    Thanks David. I use Nebula and found it as well in the AP and Port settings. Good to know where I can change it as well if I decide not to renew Nebula. I assume you have to change it for every AP when web managed? I wish there was a way in Nebula to apply it only to one AP, it changes all of them.

    George

    Screenshot 2024-07-28 at 12.03.30 PM.png
  • Zyxel_Judy
    Zyxel_Judy Posts: 2,598 image  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    Answer ✓
    Options

    Hi @George993 ,

    If your access point supports a LAN port, it will be listed at the bottom of the page.

    image.png

    To change the LAN port settings of a specific AP, click on that AP and configure the settings.

    image.png

    Zyxel_Judy

Categories

Nebula Tips & Tricks


    Read more

    Nebula Help Center

    EnglishTiếng ViệtРусскийไทย中文（台灣）