Xs1930-10 flow control?

Skyeci26
Skyeci26 Posts: 3  Freshman Member
First Comment
in Switch

Hi.

I recently bought an xs1930-10. I'm trying to establish what the default firmware setting is with regards to flow control. I can't see it in any menus on the port setup and I asked support via a question but didn't get a answer either.

Does anybody know if its on or off or doesn't exist on default setup?

I have implemented the switch within my 10gb network so am trying to establish what is the best practice with regards to flow control within a 10gb network for this switch and what it's default setting is.

Many thanks for any help

All Replies

  • Zyxel_Judy
    Zyxel_Judy Posts: 1,560  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    edited 7:57AM

    Hi @Skyeci26 ,

    We believe that your XS1930-10 is managed by Nebula Cloud, so flow control configuration is not available locally. When an XS1930-10 is managed by Nebula, you must access the Nebula portal to implement switch settings.

    Untitled Image

    Share your feedback through our survey, make your voice heard, and win a WiFi 7 AP!

    https://bit.ly/2024_Survey_Community

  • Skyeci26
    Skyeci26 Posts: 3  Freshman Member
    First Comment

    How though. I can't find any menus relating to flow control anywhere.

Categories

Switch Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）