[XGS1930] Full CLI access?

MichaelB · May 2021

Hello,

I´d like to get full CLI access on my XGS1930 switch with firmware V4.70(ABHS.1) and local management. Currently if I log with my admin credentials I can only e.g. "show running", but I´m not able to change anything, e.g. "configure terminal" is no possible.

I searched the GUI but haven´t found anything usefull. Is it even possible?

Regards

Zyxel_Albert · May 2021

Hi @MichaelB

XGS1930 is a web-managed switch. It only supports web configuration.
The CLI only allow you to use the "show" command to check switch statistics and table, like: show running-config, show mac address-table all, show interfaces status, etc...

Reminder: You may use "show ?" to display all commands which can be use with show.

Regards

eddeig · September 9

Hello,

I still have a XGS1930 in use. What would you suggest, if I want a new switch with about the same capabilities as the old XGS1930, but WITH full CLI capability?

Regards,
Eddeig

Zyxel_Melen · September 11

Hi @eddeig,

Since you need full CLI capability, you may consider the XGS2220 series.

For more information, please reference our website.

XGS2220 Series - 24/48-port GbE L3 Access Switch with 6 10G Uplink - Overview | Zyxel Networks

eddeig · November 23

Hello,

Since we have no full CLI on XGS1930, is there some way to speed up setting up "Time Ranges"?
So far I have to set each port separate which takes a lot of tome if you have to configure multiple ports.

Kind regards,
Eddeig

eddeig · November 23

https://community.zyxel.com/en/discussion/comment/31720#Comment_31720

By the way… Your datasheet is STILL misleading! See for yourself:
https://download.zyxel.com/XGS1930-28HP/datasheet/XGS1930-28HP_6.pdf

It says "Management through Telnet" - you should mention that you do not have full CLI management via Telnet!

Regards,
Eddeig

[XGS1930] Full CLI access?

All Replies

Categories

Switch Help Center