Using a Wavlink AP

Bogart
Bogart Posts: 22  Freshman Member
First Comment
in Mobile Broadband

Have a LTE7490-M904 which works fine. I am now wanting to add a Wavlink AC600 wifi extender configured as an AP. I use an unmanaged switch which seems to work fine. Problem I cannot get the AC600 to access the interent. Have spoken to Wavlink who are useless. The AC600 works fine when connected to another network I have but not the Zyxel mobile phone one. Am I missing something obvious?

All Replies

  • SELBERG
    SELBERG Posts: 353  Master Member
    5 Answers First Comment Friend Collector Third Anniversary
    edited December 11

    You have latest firmware V1.00(ABQY.9)C0 ?

    https://download.zyxel.com/LTE7490-M904/firmware/LTE7490-M904_V1.00(ABQY.9)C0.zip

  • Bogart
    Bogart Posts: 22  Freshman Member
    First Comment

    Have now loaded latest firmware but problem still present.

  • SELBERG
    SELBERG Posts: 353  Master Member
    5 Answers First Comment Friend Collector Third Anniversary

    You have a POE injector between your switch and AC600?

  • Bogart
    Bogart Posts: 22  Freshman Member
    First Comment

    I have attached a drawing of how I have it wired up.

    Schematic.jpg

  • SELBERG
    SELBERG Posts: 353  Master Member
    5 Answers First Comment Friend Collector Third Anniversary
    schematic.jpg

  • Bogart
    Bogart Posts: 22  Freshman Member
    First Comment

    Hi

    Yes my mistake obviously the LTE uses its 48v psu not 24v as I showed. It does work if I connect a signal from a different router into the switch. That is why I am thinking the LTE is the problem.

  • Bogart
    Bogart Posts: 22  Freshman Member
    First Comment

    Have tried various combinations. Different switch, a managed one, no difference. The Wavlink works fine connected into a different router so again finger of blame points to the LTE. Not so much as in its suitability more in as I think a setting is incorrect.

  • SELBERG
    SELBERG Posts: 353  Master Member
    5 Answers First Comment Friend Collector Third Anniversary

    Do you use router mode or IP Passthrough?

    If IP Passthrough try router mode, i think that could be your problem.....

  • Bogart
    Bogart Posts: 22  Freshman Member
    First Comment

    Set passthrough to off and can now access internet. Strangely I set passthrough to on as with it off originally I could only connect one computer to it any more than one and it threw a wobbly. Will see how it goes.

    Thanks and have a good Christmas and New Year

Categories

Consumer Product Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）