DX3301-T0 - WLAN AP only

Birger · December 13

I want to set up my DX3301-T0 as AP only together with its VoIP capabilities.

How do I configure the device? I have set a static LAN IP address and WAN to Bridging mode (not using WAN interface right now).

My device is missing the default gateway address, the DNS server and the NTP server.

How do I configure that?

Peter2 · December 13

But which device is in front ? A modem or a Router sucessfully connected to the Internet ?

Birger · December 13

There is a router connected to the internet. (A German FRITZ!Box in this case, but it may vary in the future.)

The wireless runs ok, but it's annoying, that the device does not use domain names, cannot reach zyxel servers and has a terribly wrong time.

Peter2 · December 13

You should give the zycel a IP adress of the fritzbox net may be easier to do with DHCP

broadband / WAN Routing IP OE Adresses and DNS automatic

connect via WAN Port

tonygibbs16 · December 24

Hello @Birger

Welcome to the forum.

I would set-up the Ethernet WAN as an IPoE connection on your DX3301-T0 and connect its Ethernet WAN port to a LAN port on your Fritzbox and let the DX3301-T0 get its IP address by DHCP, see below.

from https://download.zyxel.com/DX3301-T0/user_guide/DX3301-T0_OPAL-Series%20%28EX5601-T0%29_UG_V5..pdf

see also https://download.zyxel.com/DX3301-T0/quick_start_guide/DX3301-T0_2.pdf

I have done something similar this year with a Zyxel NBG7510, and it works well.

Merry Christmas 2024 and Kind regards,

Tony

DX3301-T0 - WLAN AP only

All Replies

Categories

Consumer Product Help Center