NAS326 system led blincking
Freshman Member
I dont know why but my NAS is not working, I try to switch on but System LED is blinking. what can I do?
All Replies
-
Does it boot when you remove the disks?
0 -
Hi! I want to connect to this topic. My NAS-326 have this same issue, but booting fine without HDDs
0 -
I have this same issue.
But, yes my NAS-326 booting well without HDDs.
With hdds system led blink for 24h and still blink, and blink. HDDs make hard work, something like sync procedure
0 -
Hi!
What if my NAS326 boot propertly without HDDs? With HDDs no (system led blink)
0 -
In that case either (one of) the disk is broken, drawing too much current, or generating gibberish on the sata bus, or the power supply is worn out that it can't deliver enough juice to spin up the disks. Spinning up the disks is by far the biggest power sink in the NAS, and power supplies do wear out.
0
Guru Member
Categories
- All Categories
- 428 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 348 USG FLEX H Series
- 291 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 404 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight
