Channel change on their own in Nebula, regardless of DCS

Options
ChristianW
ChristianW Posts: 5 image  Freshman Member
First Comment
in Nebula

Hi all,

i think my problem is related to this. I have an NWA90AX and NWA50AX connected via SmartMesh setup in Nebula.

With disabled DCS i set the channels manually for both devices in 2.4/5GHz, but Nebula is doing it's own.

Setup:

NWA90AX: 11 + 36

NWA50AX: 6 + 44

Result after reboot for both is 11 + 44. When i use DCS nebula also sets both devices to 11+44 which isn't optimal. Any chance to fix this?

Regards, Christian

All Replies

  • Zyxel_Melen
    Zyxel_Melen Posts: 4,583 image  Zyxel Employee
    Zyxel Certified Network Engineer Level 1 - Switch Zyxel Certified Network Administrator - Switch Zyxel Certified Network Administrator - Nebula Zyxel Certified Sales Associate

    Hi @ChristianW,

    May I know which is the root AP and which is the repeater?

    Zyxel Melen


  • ChristianW
    ChristianW Posts: 5 image  Freshman Member
    First Comment

    Hi Melen,

    NWA90AX is the root AP, NWA50AX the repeater.

    Best regards

    Christian

  • Zyxel_Melen
    Zyxel_Melen Posts: 4,583 image  Zyxel Employee
    Zyxel Certified Network Engineer Level 1 - Switch Zyxel Certified Network Administrator - Switch Zyxel Certified Network Administrator - Nebula Zyxel Certified Sales Associate

    Hi @ChristianW,

    Thanks for the information. The repeater AP will connect to the root AP with its channel. However, it is strange that the root AP also changed its 5GHz channel. Could you help enable Zyxel support access so we can check? Please also share the timestamp you rebooted.

    Zyxel Melen


Categories

Nebula Tips & Tricks


    Read more

    Nebula Help Center

    EnglishTiếng ViệtРусскийไทย中文（台灣）