Replace ATP200 with Flex200H

Options
TAPTech
TAPTech Posts: 174 image  Master Member
First Comment Friend Collector Seventh Anniversary Nebula Gratitude
in USG FLEX H Series

If I replace my Nebula ATP200 firewall with a Flex 200H, will it copy the settings over, or will I need to start from scratch?

Accepted Solution

  • Zyxel_Tina
    Zyxel_Tina Posts: 401 image  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - Switch 50 Answers First Comment
    Answer ✓

    Hi @TAPTech,

    Unfortunately, because your ATP200 and USG Flex 200H are managed by Nebula, direct configuration migration using a converter tool is not supported for this specific scenario. You will need to manually reconfigure the settings on your USG Flex 200H. Thank you for your understanding.

    Zyxel Tina

All Replies

  • MCFH
    MCFH Posts: 10 image  Freshman Member
    First Comment Friend Collector Seventh Anniversary

    Check the conversion tool

  • TAPTech
    TAPTech Posts: 174 image  Master Member
    First Comment Friend Collector Seventh Anniversary Nebula Gratitude

    Thank you for the tip. I checked the conversion tool, however both of the Firewalls are on Nebula. It looks like the conversion tool is only for local/non-cloud.

  • Zyxel_Tina
    Zyxel_Tina Posts: 401 image  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - Switch 50 Answers First Comment
    Answer ✓

    Hi @TAPTech,

    Unfortunately, because your ATP200 and USG Flex 200H are managed by Nebula, direct configuration migration using a converter tool is not supported for this specific scenario. You will need to manually reconfigure the settings on your USG Flex 200H. Thank you for your understanding.

    Zyxel Tina

  • TAPTech
    TAPTech Posts: 174 image  Master Member
    First Comment Friend Collector Seventh Anniversary Nebula Gratitude
    https://community.zyxel.com/en/discussion/comment/78765#Comment_78765

    Hi Tina,

    Here is how I made it a bit easy- created a new Site in Nebula with the USGFlex200H and copied over the settings. Once the settings were complete, I move the switches and access points to the new site, then deleted the old site.

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）