WAN and VLANS
Freshman Member
Hey everyone, how are you? I need some more help. Look, I have two WANs, WAN1 and WAN2, and I also have two VLANs, VLAN40 and VLAN50. VLAN40 goes through WAN1, and VLAN50 goes through WAN2. I'd like to create a rule that when WAN1 goes down, VLAN40 automatically switches to WAN2, and when it comes back up, VLAN40 returns to WAN1. How could I do this?
Best Answers
-
the status goes red when ping fail going to the next rule 2 and when ping is back up rule 1 takes over again
0
Guru Member
All Replies
-
The way it can be done is routing rules with ping check
so in order
rule 1
incoming VLAN40
next hop WAN1
ping check to some reliable IP that routed some hops a away.rule 2
incoming VLAN40
next hop WAN2and thats it when ping fails for rule 1 rule 2 takes over and you can do the same for VLAN50
0 -
Sorry, I'm using the USG FLEX 200. Could you show me with pictures how to do this setup?
0 -
the status goes red when ping fail going to the next rule 2 and when ping is back up rule 1 takes over again
0 -
Thank you very much for the information. I'll take the test and come back to tell you what happened.
0
Categories
- All Categories
- 442 Beta Program
- 2.9K Nebula
- 219 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.5K Security
- 602 USG FLEX H Series
- 344 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.4K Wireless
- 52 Wireless Ideas
- 7K Consumer Product
- 298 Service & License
- 480 News and Release
- 92 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.8K FAQ
- 34 Documents
- 87 About Community
- 105 Security Highlight
